How many pavers for a fire pit

This isn't strictly necessary but I know it will extend the life of the fire pit. I don't quite trust the coating they put on these guys, let alone the cheap hardware they included. Choosing the location was a fun one -- I decided on a spot where the grass doesn't grow well. I live in Tampa, where the water table is super low, so it's a challenge to keep grass healthy here.

The fire pit did a good job of masking that fact. Using my shovel, I chopped around and marked where I would remove the grass. I had to be careful here not to scrape off the paint, which had dried but not fully cured yet. Next, I moved the fire ring and removed the grass directly surrounding it -- this is so that I could compact the ground and so that my pavers would lay flat.

Since I didn't have a soil compaction tool, I just smashed the shovel and used my own weight to compress the soil. This is important to keep the fire pit from shifting over time. I picked up some cheap retaining wall blocks from Home Depot.

Pavers also work well, but since these are literally made to be used as a wall, they stack nicely. The fire pit is 36" in diameter, so its circumference is about ". Each block is about 9" long on the short end, so I needed 13 bricks for each "level". I decided on two levels, so this is 26 blocks total. Each block weighs 22 pounds, so my Subaru was not too happy about pounds being loaded into its rear. Anyways, as always, it made the trip without incident and I began the process of carrying them back and forth into the back yard.

This is the easy part -- since I decided not to use any mortar, the process of stacking them into a wall was easy and satisfying. For all sizes of the brick paver fire pits in the table above, only one 60 pound bag of mortar mix is needed.

The easiest way to mix up your mortar is in a wheelbarrow. A hoe or shovel will be needed to mix your mortar and you will also need a masonry trowel for spreading it on your bricks. There are several materials that can be used in the bottom of a firepit. The materials need to be able to hold up to extreme heat.

Commonly used materials are fire brick, a layer of refractory cement, sand, lava rock, gravel, and dirt. If you are still trying to decide what material to build your pit out of, use our Fire Pit Calculator below to find out how many blocks or bricks you will need to build the size of pit that is perfect for your backyard. Fire Brick Fire bricks are designed to hold up to high heat. There are two thicknesses of firebrick available, 1. Either will work.

Fire Pit Liner When looking to make your brick paver fire pit long-lasting, your other option is to use a fire pit liner, also called a fire pit insert. Additional Questions How much mortar will I need? What do I put in the bottom of my firepit? A circular fire pit measuring 37inches in diameter takes 12 pavers of 12 inches for each ring.

For three layers of paver rings a total of 36 pavers with a perfect fit can be supplied with instructions and support for building the fire pit. Building a round paver patio with a fire pit is easy if you buy a fire pit paver kit from a supplier.

You begin by measuring and clearly marking the required area which you then dig out to a depth of about nine inches. The pit is then filled with a paver base to a depth of about half a foot. Compress the paver base by tamping and then add a one-inch thick layer of sand. The layer of sand must be level for the correct laying of the patio pavers. Locate the exact center of the circle. Place the center-piece paver first and use it as a compass to lay the rest of the pavers.

The kit comes with a provision of pavers cut at angles to fit the circular edges. As you progress, ensure the pavers are level by tamping with a rubber mallet for firm positioning into the sand. Once all the pavers are in position, pour polymeric sand of your preferred color into the paver joints.